Diy antenna booster how to#

Mini external antennaĪnother way is to use any slim metal tube like a pen or drinking straw (metal) to form an antenna. Remember to aim the open end of the can in any direction till you get a strong signal to make a call.

Make sure that the other end of the pigtail connector fits your phone’s charging port. Plug the other end of the wire on the pigtail connector onto the end of the antenna connector into your phone’s antenna port. Now that the antenna array is complete on the inside, tighten the pigtail connector onto the end of the antenna connector that remains outside of the can. If the hole is too large, you may need to add washers to complete this part. Place the nut on the shoulders of the antenna connector from inside and tighten it. Push the antenna connector with copper wire attached through the hole on the outside of the can just till the shoulder of the antenna connector reaches the inside of the can. Next, solder the copper wiring instead of taping with masking or duct tape as it will dampen the effect. Take a 3-inch length of copper wire and attach it to the antenna connector by pushing it firmly into the end. Measure the neck of the antenna connector to know how large the hole needs to be. Next, use a knife to cut a round hole 3.75 inches up the side from the closed bottom. Alternatively, you may choose to use adhesive-backed copper tape, overlapping the joint between the two, and seal the tape to the metal on either side, firmly. Before adding the solder, apply heat to the area to be soldered with the tip of the gun. Heat a soldering gun and carefully solder the open ends of both the cans together to form one tall can.

Pigtail connector compatible with your cell phone modelįirst,remove any labels or paper wrappers from the exterior of the cans and wash them thoroughly.Allow them to dry.Next, cut both ends from one can to form a tube and leave one end intact on the other can.

2 coffee cans, a metal cookie canister, or something similar.

Tin Can signal amplifier Supplies you need: Let’s dive! What are the different methods to make homemade cell phone signal booster? 1. There are different ways and methods to build a homemade cell phone signal booster and most of them require simple changes to one or two of the materials.

Interestingly, this signal booster can be made using inexpensive items from a local hardware or electronics store.

Diy antenna booster how to#

Don’t worry, we have you covered!In this article, we discuss how to make a homemade cell phone signal booster. Additionally, antennas, amplifiers, repeaters, and even mini-towers are available but again, they are expensive as well. While commercially available cell phone signal boosters can help, their cost can be significant for most people. To seek a signal most people try standing on a chair, crawl under their desks, or even strike some kind of yoga pose! All this can be infuriating. Surprisingly, a large number of cell phone customers complain about not receiving signals inside their homes or workplace. Are you struggling to get enough signal to make a simple call? You must consider making a homemade cell phone signal booster.